Kidde Smoke & CO ProSeries Talking Alarm, Ionization-120V Hardwire with BBU

  • Part # – 900-0119
  • Voltage – 120V

Description

120 V AC Talking Smoke & Carbon Monoxide Alarm

Combined Smoke & Carbon Monoxide Alarm – A single unit can be installed where previously, two were needed. Reduces installation time and protects against both fire and carbon monoxide dangers.

Intelligent Sensor Technology – Combines the detection capabilities of an ionization smoke sensor with that of an electrochemical carbon monoxide sensor. When either sensor notices a potential hazard, the alarm will adjust its smoke sensitiivity to differentiate between a real hazard and a false one.

Voice Warning – Announces the hazard type detected (in English and French). Alarm announces “FIRE” when a smoke or fire hazard is detected and announces “WARNING! CARBON MONOXIDE!” when a CO hazard is detected. Also announces “LOW BATTERY” when it is time to replace the batteries.

120 V Interconnectable – Will interconnect with up to 24 other devices (18 of which can be initiating), including smoke alarms (limit of 12), CO and heat alarms.

AA Front-Loading Battery Backup – Change batteries without the need to remove the unit from the ceiling, providing continuous protection in the case of a power outage.

Tamper Resistant – Unit will lock to mounting bracket to deter theft or tampering.

End of Life Notification – Ten (10) years after unit is first powered, this alarm will beep two times every 30 seconds to indicate it is time to replace the alarm.

Alarm Memory – The green LED will flash every second during alarm. When the alarm condition goes away, the originating alarm unit will flash the green LED every 16 seconds until the Test / Reset button is pressed, thus resetting the alarm.

Multi-function One Button Design includes:Test Feature – Tests the alarm circuitry and triggers the voice announcement

Hush Feature – Temporarily silences nuisance alarms for approximately 9 minutes (will announce “HUSH MODE ACTIVATED,- or “HUSH MODE CANCELLED.”).

Reset Feature – Resets the carbon monoxide alarm

Peak Level Memory – If alarm has detected a CO level of 100ppm or higher since it was last reset, the voice alarm will announce “CAUTION, CARBON MONOXIDE PREVIOUSLY DETECTED

Reviews

There are no reviews yet.

Be the first to review “Kidde Smoke & CO ProSeries Talking Alarm, Ionization-120V Hardwire with BBU”

Your email address will not be published. Required fields are marked *